17046 Exposure Head HEAD: multiple edges detected - verify image position All This is not an error - it is an informational message only. While searching for the edge of the plate, the head "saw" two edges. The "media x edge" parameter was set to 2, so this condition is allowed, and the first edge is taken as the true edge. Each time this occurs, the "state imaging double_edge_count" is incremented, and this warning message is sent to the workstation. The total count can be checked with the "list stats" command. The edge of the plate was not well defined, so the registration may be inaccurate. Check the image position on the media, and re-run the job if necessary. If this happens frequently, contact the CreoScitex Response Center. Poorly cut plates Inconsistant emulsion Incorrect surface reflectivity setting ../nvs/media_cal_edge.xmlNVS: media edge ../nvs/imaging_state_double.xmlNVS: imaging double ../nvs/media_cal_sr.xmlNVS: media sr ../nvs/hdm_cal_sr.xmlNVS: hdm sr ../commands/list_stats.xmlCommand: list stats ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:35 2008 PST